Cabling Chronicles

How to Set Up DSX-5000 for New Installation?

Getting the right setup to ensure the best test results with your DSX-5000

If you turn up to a new installation with your new DSX-5000 then it might be up to you to ensure the DSX-5000 is set up correctly. So what do you have to do?

Well, if it’s brand new out of the box, then you need to do a basic set up. But, with every new project there may need to be changes if you make installations tests in other countries or time zones with different requirements for date or time differences, or different formats for them or numbers.

August 25, 2016

Cable Testing 101: There's No Gain with "Gainers"

In a recent Cable Testing 101 series blog on mixing multimode fiber types, we covered the considerations surrounding mixing legacy 62.5 micron (µm) OM1 fiber with today's laser optimized 50µm OM3 and OM4 fiber and highlighted the "gainers" that can happen when transmitting from a smaller 50µm fiber core to a larger 62.5µm fiber core.

August 19, 2016

Cable Testing 101: Measuring Insertion Loss for Fiber and Copper

The amount of energy that a signal loses as it travels along a cable link used to be referred to as attenuation--the verb attenuate being defined by Merriam Webster as "to reduce the force, effect or value of something."

August 18, 2016

How to Measure the Loss in the APC Connector?

This question often gets asked in my classes at the same time as when talking about launch methods using launch and tail fibers. So let’s talk about launch fiber compensation.

August 11, 2016

Understanding POH: The Power Behind HDBaseT Technology

 Last month we posted a blog about HDBaseT that explained the application and how testing isn't really any different since standards-based Category 5e, 5 or 6A will support it. But maybe you've also heard about power over HDBaseT, or POH, and you're wondering how that differs from power over Ethernet (PoE).

A Little Bit More

August 4, 2016

All About Alien Crosstalk Measurement

Alien crosstalk is a relatively new measurement that’s widely misunderstood. I’m often asked why it’s an important measurement and if it’s required to be measured by the standards. Also misunderstood is the sampling criteria for alien crosstalk measurements, which are applied so that not all links have to be tested?

July 21, 2016

Demystifying Fiber Test Methods – Back to Basics

INTRODUCTION

July 19, 2016

Cable Testing 101: What is the Difference Between OM3 and OM4?

 

Blogpost Series IconOM3 and OM4 multimode fiber are two common types of fiber used in local area networks--typically in backbone cabling between telecommunications rooms and in the data center between main networking and storage area network (SAN) switches.

July 14, 2016