The page you requested does not exist. A search for CopperPro Terminator Far End Terminating Device 13 Testing Advantages resulted in this page.
13 Testing Advantages

  1. Loop terminations and VF / WB single tones for testing on either of two pairs (Pair 1 and 2)
  2. Bridging / splitting access between Pair 1 and Pair 3 (CO Pair
  3. Composite VF and WB tones for greatly increased testing speed
  4. DTMF signaling control on both Pair 1 and Pair 2 (Pair 1 alone, if powered down)
  5. Signaling and testing on the same pair (either Pair 1 or 2)
  6. Extremely low-power mode when turned off
  7. DTMF transceiver switchable via relay to either Pair 1 (default) or Pair 2, or removed from both for a preset time interval whenever its input impedance would affect the 990 CopperPro measurement from the far end (i.e., shorts and grounds, or opens)
  8. Operable from a standard butt-set, when line powering is present (i.e., idle POTS line)
  9. DTMF command protocol allows for "Ack / Nack" closed-loop feedback response to control commands, increasing reliability
  10. Tracing Tone mode (TR metallic 577 Hz signal)
  11. Powered by a standard, off-the-shelf 9 VDC Alkaline non-rechargeable battery
  12. Battery cover removable without the use of a tool
  13. Operates from an external 12-15 VDC power source, such as the AC and DC power cords provided with the 990 CopperPro, automatically disconnecting the internal battery when plugged in